Good old DataServe
That was quick. Three screws here.
Two on the green thingy and the
other on that pointy metal bit.
All very technical
Me pointing at the pointy metal thingy
Screws removed and drive belt needs
to be removed from the large pulley
then the second under the green thingy
over that screw place of the sharp pointy
metal thing and off the bottom wheel
Hmmm.. The belt wasn't that stretched
OK the belt is now removed
Time for a bit of spring cleaning
Very dusty
Those red pads tend to make the
belt twist. Odd that
I guess the belt is designed to
slightly twist around the top wheel
Basically the belt is square in section
Seems to run OK
Man is the motherboard dusty
Can't leave it like this
Dreadful state
That's better. Troubled by the
tracks at 21. Discoloured from what ?
Much cleaner
Looking better already
Still a bit of dust around
Don't like to work some of the
components too hard in case they
break off the board
Good old ZILOG
OK the tape is now working and
not jamming. It runs freely back
and forward. Sadly though getting
a read error. Time to use my head
cleaner and pull out the cotton buds
That did the trick. No problems now
Hmm what to do ? What to do
I know !!
Time to do some hacking
So what name shall I use ?
I'm in !!!!!
Time to get hacking
Thanks for that
Seems I have a message
Just a game
Anyway I'm all done. Tape and computer
working so time to lock this down